Please Note
---------------------

Adding any electronic accessories onto any vehicle may cause unexpected results. Tiny Brite Lights are tested multiple times during the production process to insure that they will not interact negatively with modern RC systems. We strongly advise that you confirm proper operation of your vehicle, both prior to and following installation.

Navigation Lights

IMPORTANT:

Prior to installation disconnect any speed controllers and batteries to prevent possible injury

1. Determine which spare channel on your receiver you would like to use to connect your Tiny Brite Lights.

2. Access the receiver on your RC and plug the set’s univeral connector into your selected channel as you would with any standard servo.

3. Reconnect batteries and power up the reciever and transmitter. The Navigation Lights will automatically turn on.

4. Route and affix the LEDs and wires onto the RC using clear tape (reccomended) or epoxy. Avoid routing near exposed gears/mechanical linkages!

5. Stow (tape or glue down) any extra wire out of the way of mechanical parts.

6. Reconnect any disconnected speed controllers.

MICRO Lights

IMPORTANT:

Prior to installation disconnect any speed controllers and batteries to prevent possible injury

1. Disconnect battery from the aircraft's receiver.

2. Connect the MICRO Lights to the battery.

3. Decide where you want the Red, Green, Strobing Whtie and Spot LEDs to be placed on your aircraft.

4. Route and affix the LEDs and wires onto the RC using clear tape (reccomended) or epoxy. Avoid routing near exposed gears/mechanical linkages!

5. Stow (tape or glue down) any extra wire out of the way of mechanical parts.

6. Disconnect the MICRO Lights from the battery.

7. Turn on the transmitter.

8. Connect the MICRO Lights to the receiver's battery connector.

9. Connect the battery to the MICRO lights. All lights should be working, and the aircraft is powered and ready.

10. Go Fly!

subMICRO Lights, Deluxe Lights, Wig-Wag, Afterburner/Double-Burner, Landing & Spot, WWII Machinegun, Beacon

IMPORTANT: Prior to installation disconnect any speed controllers and batteries to prevent possible injury

1. Determine which spare channel on your receiver you would like to use to connect and control your tiny Brite Lights.

2. Access the receiver on your RC and plug the set’s univeral connector into your selected channel as you would with any standard servo.

3. Reconnect batteries and power up the reciever and transmitter.

4. Test selected channel to see if Tiny Brite Lights respond to RC control.

5. If necessary, make adjustments on your transmitter regarding sensitivity / digital trim for the selected channel. (Please see your transmitter’s Owners Manual for more information)

6. Route and affix the LEDs and wires onto the RC using clear tape (reccomended) or epoxy. Avoid routing near exposed gears/mechanical linkages!

7. Stow (tape or glue down) any extra wire out of the way of mechanical parts.

8. Reconnect any disconnected speed controllers.

Specifications

•  All units have a universal connector so they'll work on Futaba, Hitec, Spektrum and many other popular receivers.

•  Weight of each individual unit is approx. 3 grams.

•  Current consumption @ 5v < 15mA

•  LED brightness

Click here for a list of retail outlets that carry Tiny Brite Lights